Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to have the default route from one VRF be imported into another VRF and then learned by the rest of the network on VRF. Below is a basic configuration we are using. When using this configuation the default route that is being originated fr...
We are blocking Streaming Media and Online Communities. However, I now have a business case to allow access to specific content areas within specific sites in those URL categories. One of the sites is YouTube. I know I can create a Custom URL categor...
I'm sure this is a simple configuration issue but here is my issue:We are running an HTTPS service on a host that is connected to our DMZ network on our ASA. This host and ASA can communicate just fine. I've created an ACL rule that allows HTTPS traf...
Is anyone out there using a ClearOne VH20 for integration a board room conferencing solution? I would like to be able to control a conference call via the ClearOne device using a Crestron control unit.Basically, I would like to be able to have more t...
I have a situation that I believe is an IOS bug but I didn't see any notes on it. Can anyone see if I'm just missing something in my config.We have 2 interfaces that connect to 2 different 3rd party networks. We NAT our network to protect our interna...
Ajay - thank you for your response.I did solve my problem. It hit me after I posted my discussion (sometimes just saying it outloud helps). Anyway...It hit me that the NIC shouldn't have been making an ARP request for an IP not on it network. If anyt...
Yes, we got the ClearOne working just fine. The configuration wasn't as intuitive as you might expect but once I added the IP of my CM to the Dial Plan page life was good. During the process I did make some very good contacts at ClearOne and their su...
Brian,I completely agree. This situation presented itself to us as a new customer who we were developing a new network design for as this problem introduced itself. The current routers where having CPU issues at least to the point where introducing Q...
Everyone,Finally it appears we have a "band-aid" on the problem. We performed tuning on the output queues (using the hold-queue statements) on the serial interfaces and multilink interfaces. The final config had the output queues on the serial interf...
Brian et al,We put in a new router a 3640 (which basically doubles the performance of the 2651XM) and the problem got worse. Not sure why. I finally got a Cisco TAC case open (long story why we couldn't open one) and the Cisco engineer suggested the ...
