Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
I am looking for a document stating , 9800CL on Hyper v cluster does support HA-SSO. I could not find this information over internet but i can see support for EXSI other platforms. Any input will be appriciated .
Regards,
MD
Hi,My ISE environment is hitting bug CSCvv41074, I am trying to install the patch but getting below error. Patch cannot be installed. Patch file is not in the correct format. The Hotpatch apply and rollback are available on https://software.cisco.com...
Dear all,I have an issue with profiling services, which is not working for cisco IP phones. Setup : 1. Cisco IP phone testing with CP8811.2. Cisco ISE distributed mode in 2.6 patch 73.L3 interface is configured with DHCP IP helper for PSN nodes Issu...
Hi All, I am facing a strange issue with ISE distributed deployment of 4 nodes. We have 2 MNT/PAN and 2 PSNs. shows running-config output shows eth0 to eth5 interfaces only on 3 nodes (ISE1 , ISE2, ISE4)but except ISE3 (Which is one of the PSN). I h...
Hi,Its a kind of annoying to see many of the following logs throughout the day in cisco ise. Jan 14, 2020 02:27:05.460 PM INVALID Default >> DefaultDefault why the switch is kept on sending access-request massages from the port, where the device had...
@MHM Cisco World OK,that's the answer i get from most of the technical expert. How to get a confirmation, we have to desgin it for a business requirement.
Hi , Yes, Now I can see the name "admin" and getting the following logs. But no one tiring to authenticate, i have configured only a single port for dot1x and MAB. Both IP-phone and laptop is working fine.. If i disconnect one of the device from that...
