About madhur_malik

madhur_malik · 02-16-2005

I have connected 2 Cisco 1721 routers (Back to back) using DTE & DCE cable. At DCE end I have given clock rate also. But the serial is not coming up. Its showing Status down & protocol down. Also when checking Show controllers s0, I am getting “DTE ...

madhur_malik · 06-27-2004

I have configured NTP (Network time protocol) on one of our windows 2000 server and we have tested NTP server by configuring the clients machines andclients machine are able to synch the time from this server but we are not be able to configure the r...

madhur_malik · 08-18-2006

Setting up Time Server in Windows 2000 Server will not be able to sync Routers and Switches clock as both uses different version.In Windows its SNTP -Simple Network Time Protocol.In Routers/Switches its NTP - Network Time Protocol.You can configure a...

madhur_malik · 08-18-2006

1) No its not correct. 2) No you can't configure B channel Interface directly.3) Simply configure dialer as a backup interface, also put below config in the dialer.ppp multilink ppp multilink load-threshold 180 either this will make the dialer interf...

madhur_malik · 05-29-2006

Yes Its very much possible. Configuration at Router side will be default only. Just you need to keep some points in your mind which configuring.1.Its works perfectly fine with PPP-PAP. Tried with PPP-Chap also but was unsuccessful.2.Sometimes requir...

madhur_malik · 05-28-2006

Hi,You will be not able to configure B channels. As per my understanding you want to configure seperate interfaces for individual location.You can create dialer & make it the pool member of PRI D Interface i.e. s2:15.I think this will solve your pr...

madhur_malik · 04-14-2006

Hi Suresh,As you have created seperate dialers for each branch. It seems that ISDN Calls are not getting bounded with respective dialers.a) You can add "dialer caller XXX" command in all the interface where XXX will be the remote ISDN number which...

Member Since	‎01-12-2002 08:48 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	9

User Statistics

User Activity

Serial Link not coming up

Unable to sync the with NTP Server

Re: NTP Configuration

Re: ISDN BRI both channels into E1

Re: isdn connections

Re: ISDN PRI on E1

Re: ISDN Problem