Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have an issue problem on one PE (PE-3), if I doing test from the neighbor or another PE to PE-3 using "ping mpls pseudowire <loopback PE-3> <VCID>" and ping using vrf to PE-3 there is many packet loss, but ping test to loopback PE-3 is normal n...
Hi,Anyone know the cause of the problem below ? This log appeared after ospf establish.%OCE-SP-3-UNEXPECTED_SW_OBJ_TYPE: SW_OBJ handle/type mismatch; expecting oce type label, found 1Thanks,Gilang.
Hi,We have a case MPLS 6PE configuration as below, we can't ping inter vrf in local router from the gateway, but i can ping & browsing from my PC/router behind PE using gateway vrf Test-IPv6, any solution regarding this issue ? Has anyone ever encoun...
Hello,I have a Problem with one PE using Cisco 7206VXR (NPE-G2), The PE only reboot automatically, The following log in PE during and after reboot, Whatwhat causes this problem occurs ? We already replace device the PE using the same type of router b...
Hi,if anyone has ever had the experience VRF Upgrade from ip vrf <vrf name>to vrf definition <vrf name> using command vrf upgrade-cli multi-af-mode non-common-policies vrf ? if I want to use these commands, whether there is downtime for the vrf ?Than...
Hi Nagendra,Thanks for your respond, I've try again using configuration vrf definition .. but still failed and still the same result. may I know the IOS and router type are you using? may be for your information, I use a router Cisco 7600 series with...
