Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When I do a "show disk" get the following - where the "c:/4123 FLO.WMG..." is repeated alot and then eventually shows the disk info. The system is still running since the it has not been rebooted:CSS11503# show disk PCMCIA Slot: 0"c:/54122 FL.OWM" h...
Not sure if this is the write discussion group.Has anyone set up Glassfish OPENSSO servers to be load balanced through a CSS (in this case, 11503)?We have not been successful in getting Glassfish to accept connections through the CSS, although, if we...
I am using Wireshark on a PC with a GBit interface and plugged into port gi1/0/1 - with monitor set up to look at port gi1/0/18 in VLAN Y - gi1/0/1 is in default VLAN 1. The only traffic that I can capture to/from my VLAN 1 address is when I ping fr...
We are using the LD 417 to load balance across Sun webservers running Oracle Apache. We have just seen a problem where IE 6.x, accessed through the LDs, will not apply style sheets in Framesets, unless the page is refreshed, either by the user or p...
Ok....I had looked at the documentation before and saw theLoad/Average LoadThe current and average load for the service.but I did not find a definition of 'load' or an association with connections or what the average load is and how is it calculated....
