Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am attempting to set up 802.1x authentication on our Cisco 7942 phones and I am not really too familiar with the settings. We have several small sites that use Aruba RAP devices that are centrally managed by an Aruba controller. The authenticatio...
I am attempting to upgrade the IOS on all of my Cisco 3560 switches at remote sites. I am having issues performing this transfer remotely. So I am using a management server located at our datacenter as the TFTP source. I have installed both TFTPD3...
I have a switch at a remote office. I have a Cisco 2851 Router and two cisco 3650 POE switches. I also have three Aruba 105 POE APs. Two are plugged into one switch, and one into another. Yesterday we had a power issue that caused all of the equipm...
I have a Cisco 3560 (Switch B) switch I just introduced into my network. The gigabit ports are trunked from another switch (Switch A) to a Cisco 6509 WS (Main Switch). crpf4bsw3#show cdp neighborsDevice ID Local Intrfce Holdtme ...
Unfortunately that's not an option here unless I ship mine out and walk a standard non-technical user through the process. But I will tell you that we moved the AP that was in port one into several other ports on the same switch with no response fro...
Hi Mike, It looks like you're guiding me in the right direction. I did a "show port security interface fa0/2" on the new switch and nothing was out of the ordinary with the exception of the 0 MAC addresses learned. But then I did a "show spanning t...
Here is the entire table. I currently have a 7940 plugged into port fa0/2 (and it's recognized as up) and I had my laptop plugged into the same port prior to that.crpf4bsw3#show mac-address-table Mac Address Table---------------------------...
