We have a Wireless Control System, 3 WLC and 190 APs. I need to monitor 802.11 radios through SNMP. The system is running with LWAPP and the APs are not accesible through SNMP (no response trying to acces them). I try to send traps to the SNMP server...
Hi Forum:I need to monitor through snmp the Out of Service radios of APs. The Wireless Control System give me through web based application that number, but I need on snmp. I really appreciate if somebody can confirm if this value is accesible throug...
Hi NetPros:Is there any way to force the outbound interface of the router?I mean, when router does ping, dns, queries, ntp, etc... is doing with the interface nearest to destination, does it?I need router do queries, pings, and so on with source inte...
I've been looking for a solution to forward a port range for months, and I haven't any solution yet.I am CCNA Certified and CCNP cursed. I've asked to my teachers, in conferences and my isp support. Nobody knows how to do it.A common task like this, ...
What is the best way to forward a port range to internal ip address and don't lose the router internet access?My situation:I've a SHDSL connection with 878 (IOS version 12.4) and one public IP.If I configure:"ip nat inside source static <private ip> ...
At the moment, I don't see that trap cause any radio go down. I try to disable it down administratively from the WLC console but not send the trap.I will hope that if the interface goes down, I see the trap...Regards,Olaf
Thanks Nicolas...I can query the Table of Interface Status but it is very hard to monitor due to the Index Interface is dynamic. I try to monitor through traps...
Thanks Eric,I have the script running ok. But we will need a lot of programming work for reach our goal. "Zabbix Triggers when radios down". We are in the correct way thanks to you.If you have any other advice i will thank you a lot.I set the questio...
Very, VERY, usefull Eric.In order to achieve the goal (knowledge of OoS radios and whichs) from the WCLs I guess that need some scripting.But I don't understand the values of the OID after the OID we are querying...[OID Query].0.25.169.166.241.176.0I...
