Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dears,
I was trying to setup ikev2 L2L vpn but couldn't manage to setup , I will try again to setup where it is failing only the thing that I want here is how I can easily see the debugs logs in ASDM or on terminal becz when I run debug crypto ikev2 ...
Dears,
I want to change the client service port from 443 to some other port, I want to know which port range should be used for this client services, if I m not wrong the private port cannot be used.
crypto ikev2 enable OUTSIDE client-services port...
Dears,
i want to configure private Vlan in my network to secure host within the subnet, i have all Default gateway on my ASA service module, how i can configure the promiscuous port settings on the 6509 switch and also i have a cisco IP telephony net...
Hello,After upgrading the IOS for crypto features,there is no command IP HTTP SECURE-SERVER in IOS and also i can't do WEB Browsing through HTTP??? though i have applied a command IP HTTP SERVERThe IOS uploaded to c2950-i6k2l2q4-tar.121-22.EA13 al...
Dear's,The Supported device list below by cisco does'nt support Express 500 as a Edge deployment but in my network i m having Express 500 and they are passing packets through NAC they are supported.How ????????? Can anybody brief me abt this.Also ca...
I am giving my customer anyconnect vpn client directly by dropbox I want to disable the client services completely or to some other port so that the public IP should not be accessible from Internet on well know port.(443)
Hence whenever the us...
Dear Mink,
Once the logs start to arrive the session gets disconnected so how they will be collected in the log file becz the session gets diconnected???
how I can enable logging buffer for specific vpn logs only and I can see them in the buffer...
Hello,So my recommendation is to delete "privilege" commands from your switch and to leave your "Shell profile" to the defaults. Only use "command sets".There are no privilege commands on switch only on ACS Once i remove the privilege level the user...
