Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I had an existing 2-networks, connected in a single connection to the core switch through the ISP DEMARC,The 2- network was connected to the Core SW through the single node.The 2-networks was communicated through the layer 2, each Sw has his own vlan...
switch 2960xTCAM region 24 error: move failed, source index 4828 target index 4829.My Cisco switch 2960x run layer 3 warning error system messages -critical Description: TCAM region 24 error: move failed, source index 4828 target index 4829. is ther...
I have Cisco IOS Software, C2960X Software (C2960X-UNIVERSALK9-M), Version 15.2(2)E3, RELEASE SOFTWARE (fc3)
and I created an access-list to prevent my network to access other 4-networks, the 4-networks I can not access the SWs.
when I tried to conf...
Which IOS version for the SW 2960 X 12.2 (XX)SE(X) will support the Track command
because I have 2960-X with IOS version 12.2(55)SE7 but not supporting the Track command that I want to use it with The IP SAL
according to the updated drawing that I have attached, you will fine that SW-1, Sw-2 & sw-3 were communicated through for example vlan 10.sw-1 was communicated to the other switches in different vlans( for each switch L2 had his own vlan and his own ...
Hi Bro,I had several SWs, that I need to do changes on their configuration without saving the new config, bcz as soon as I will apply these changes, I lose the remotely access, so I was wondering if there was any way that I could scheduled the SW for...
