Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm not sure if the tital is correct but essentially I have my 4948 as a core switch which has a layer 3 interface to my router and all of that works great HOWEVER. I need to configure a way to have 1 vlan on my core and the 2960s trunked to it to ha...
So i recently got a great deal on a 4948 with the 10GB modules included. I have them installed correctly and purchased a 10GB OM3 LC-SC 1 meter fiber cable that connects the switch to my Mikrotik Router. So Mikrotik lists the SFP and connector type w...
So i have a 2960 switch that has the fancy web UI. It's the Catalyst 2960-S Series Device Manager to be specific. I have the cat4500-entservicesk9-mz.150-2.SG11 image on the switch but it appears that it does not come with a web UI like the 2900 seri...
So i have searched around everywhere, google, here, microsoft. I haven't found any solution yet and re-imaging the PC is not a solution.
But i am trying to install the AnyConnect Mobility Client on an employees PC and it will not get past copying fil...
So i haven't done much with any of my cisco knowledge within the last few years(military). I am setting up two 24 port 3650v2's, one in my basement and one in the guest bed closet.
I am just setting up all this to refresh my memory and learn some up ...
Okay perfect that was my original config and still is minus the private vlan option in the vlan database and it doesn't seem to be working BUT I think I found the actual issue and that's totally on me as well lol. I forgot to make a crossover for the...
Yeah the plugs are going into the correct ports light/transmit and receive wise. I'm not sure if it's something with the Mikrotik end or the module itself on the switch. The only thing that leads me to believe it's not the switch module is because th...
Just swapped them on the SC end with no luck. The side (black marked) with light being sent from the LC is going into the RX on the X2 module naturally if that helps troubleshoot a little more.The SFP+ is an SR 10GB module if that helps also.
Bummer yeah i know they are meant for DC's but i figured they would provide some sort of web UI like the 2K and 3K series. No worries though this is more of a question about the web UI then how to get the 2K series web UI to show lol. Thanks for the ...
