Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
we purchased some AIR-CAP2802E-A-K9 APs to replace existing 2702E APs, we checked approved antennas with Access Points 2800 on Cisco website and found all the antennas are multiple connection (four cables), as we are using antenna cables (5 - 25 mete...
i have an ip that is part of our internal network, i configured route map on the core to redirect the traffic to the firewall for further inspection.i checked the firewall logs i can see the traffic is redirect to the firewall successfully. i could p...
the request is when the traffic hit the public IP on port 222, i need to redirect to a internal server on port 22.mu configuration is like this: object network FTP-Accessnat (dmz2,outside) static FTP-SVR-Public service tcp ssh 222access-list global_a...
My company using 4500 as core switch, recently we plan to replace all the windows desktops with Apple computers.in order to use Apple Bondour cross the vlans for the Apple devices discovery (wired connection), i enabled ip multicast routing on the c...
the configuration has been changed , because we decided to use the same port 22 and it works fine. thanks for you help.i will set up a lab to do more tests for this issue. thanks
the static nat is above the dynamic nat, we using different public IP for different port forwarding, and the PAT still go through the main public IP.object network FTP-Accessnat (dmz2,outside) static FTP-SVR-Public service tcp ssh 222!nat (dmz2,outsi...
The ACL works only for traffic going through the switch, actually it works.
i am not able to reach the host which is sitting in the vlan 50 from other vlans except form vlan 20.
but i still can ping the gateway 192.168.50.1
