Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am looking on how to go about getting Ether-channel working with a vDS with vCenter 5.5 we have a L3 Switch but since we already have our ip address set per vLan i think L2 Etherchannel will do.i am using LACP protocol. Also is load-balancing autom...
We currently have a Cisco 3750x 24port Switch in place but are now going to replace this with a 48port 3750x what are the best practice to replace the old Switch could i copy the running config file and place it into the new Switch or would creatin...
Quick question;is it possible to have the Cisco Switch to shutdown if the temperature goes above recommend temperaturecurrently we have one Cisco Switch C3750x. Thanks..
Could some one help me please with NAT. I have a C licence (195.100.190.0/24) A ISP WAN that connects to the Customer site uses network Address 199.1.1.36/30 & Loopback 126.0.0.1/8 i have on ISP ISP#show run Building configuration... Current con...
Trying to Set up ACL'sI have 3 Routers with Pcs on Each, On R1 Deny PC1 to PC3, And on R2 for PC2 only allow www permit nothing elseSo far i have this,,on Router 3ip access-list standard no_accessdeny PC1 IP address Wild CardPermit anyaccess-list 10...
Hi Paul the Switch is already connect to a ESXi Host with vDS enabled if that helps,i am looking at getting Etherchannel enabled. when i set the default mode onit was using Protocol Pagp which isn't supported by vCenter.
When you are talking about Stacking will this allow the master to push the vlans to the Slave and then would this allow us to take out the old Cisco Switch ?
OK, I got the ACLS working but wanted to check the port 80 on ISP working for Router 2 i blocked every other port. I added a Server on the ISP, gave it the 172.190.1.2 ip address with gate way 172.190.1.1 i check the all devices can ping it but and...
