Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
This is also seen on the Nexus 7010
Software BIOS: version 2.12.0 kickstart: version 7.2(1)D1(1) system: version 7.2(1)D1(1) BIOS compile time: 05/29/2013 kickstart image file is: bootflash:///n7000-s2-kickstart.7.2.1.D1.1.bin kic...
In prime 3.1, Planning mode does not allow me to expand the coverage area. Expanding the coverage area under prime 2.1 was accomplished by holding the ctrl Key and expanding the blue dotted rectangle. Its ridiculous if this function is missing.
...
Because a BGP route route in r> (rib failure) status is not redistributed into another routing process (i.e. OSPF), how long does it take for that route, once it is moved from r> (rib failure) to *> active, before it is dynamically placed into the O...
To add to this, I'd like to see prime notify on high input utilization. I get high output utilization emails, but none for high input utilization. Prime LMS 3.1.
I have this problem also. The multicast traffic comes from the HUB location where the controllers are located, get encapsulated into CAPWAP tunnel, and sent to all the access points located in every branch office. This traffic is saturating my smal...
Hi Lars,
Thanks for the update. My memory may have failed me. The problem was that I was working from the wrong page. I was trying to update the first page with the dotted blue lines.
