Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
We are trying to installing Wass-accelerator 4.4.3.bin file on WAE SM-SRE-710-K9 module from FTP server but we are unable to install and got some error.
Router1#service-module sm1/0 install url ftp://user:password@10.22.1.132/D:/Ankit/WAAS...
We need your help !
We are facing issue with WAE device model WAE-5SM-SRE-710-K9 as not accessing through telnet.
We have configuring the WAE - SM-SRE-710-K9 Module on CISCO2921/K9 - Version 15.4(3)M1 .
Problem is we are unable get telnet our SM-SRE...
Hi All,
Please Help Us.
We are using Cisco SG - 300 / 28 port switch
We are configure Vlan and Trunk allow Management vlan commands on switch , but not showing on running config ,and interface .
This are commands using :
EX : Int range gigabitether...
Hi !
We are unable to ping WAAS WAE -7341 -k9 ip address!
i was check the cable and Reset also ! we are unable ping 1
We are getting system locator led indication on devices
regards
Asif
Hi All,
Please help us.
We are using Cisco SG300 switch and CISCO2921 router ! We are unable to ping and telnet router to switch SG 300 , but we are getting ping router to PC , PC to router
Cisco Router
interface fa 0/1.22 encapsulation dot1Q 22 ...
Hi finn
After Install wass application software on module(SM-SRE-710-K9) , we are getting offline error on WAAS center manger .
Cisco Wide Area Application Services Software 4.4.3
And
Center manger Cisco Wide Area Application Services (universal-k9)...
Hi Finn,
We need your help !
We have configuring the WAE - SM-SRE-710-K9 Module on CISCO2921/K9 - Version 15.4(3)M1 .
Problem is we are unable to ping our SM-SRE 710 module ip 10.22.12.5 .
Please check below config.
EX : interface SM1/0
description...
Hi Hami,
We need your help !
We have configuring the WAE - SM-SRE-710-K9 Module on CISCO2921/K9 - Version 15.4(3)M1 .
Problem is we are unable to ping our SM-SRE 710 module ip 10.22.12.5 .
Please check below config.
EX : interface SM1/0
description...
Hi Nagasheshu,
We have configured 20 to 30 cisco sg-300 switch with the same configuration commands !
it is working fine , but issue come with 2 switch only ,
configured on switch but not showing on interface and sh run configuration !
EX : Int...