Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello there, hoping someone can point us in the right direction.We have a Cisco 2500 Series Wireless controller that pushes out the WLANs which use the dhcp scope on the WLC we use which were setup for us when the WLC was originally configured.We wan...
Hello All
Newbie here hoping you can help. We have an asa 5516 firewall and are currently doing some work with the supplier of our library system. They have recently changed their isp and when we tried cutting over their connection didn't work.
I had...
hello there
hoping you can help. We run a mix of win 7 & 10 ENT 64bit computers and use the anyconnect-win-4.1.08005 vpn client. Recently we moved from Symantec endpoint protection to Trend OfficeScan XG but have found that any computer that has Tren...
Hi all
Hoping someone can help. Our WLC sits on a subnet 192.168.5.0/24, the wireless dhcp address pool in question is 192.168.10.0/24 and we are consistently running out of ip addresses.
We would like to increase the pool to use the 192.168.11.x sub...
hello all
we are hoping someone can help. We have 4 x P4500G2 nodes connected to our core switches and noticed that the Flow control settings on the cisco 3750 switch is different.
We have 2 of the nodes has their ports configured as Flow Control R...
Hi There
Thanks for your reply. The issue isnt the client running, once its installed it works fine. The issue is getting the client installed in the first place. We have found a work around by unloading the trend av client, doing the install, and re...
Thanks for that. We already put the exceptions in and that actual VPN client works fine once its installed even with OfficeScan installed, it's the first time installation or update of old client that fails.
Hi Flavio
Thanks so much for your reply. We are very new to changing this type of setting and were wondering what the 'best practice' thinking was on this?
I'm thinking we will go ahead with the steps i mentioned as we will then have to go on to our ...
