Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello EveryoneWhat is the best practise for positioning the Access Point and antenna. AP models are 2600 and 3600. Can we change the radio coverage area of an AP from a WLC Thanks < Joe >
Hello ExpertsWLC 5508 and AP in the same location is working great, what config steps are needed to register AP located in remote office with WLC in HQThe Subnet range in remote office is different but WLC reachability is there.appreicate feedbackche...
HelloI got 5VLANS and need to restrict two servers access to all vlans except Mangement vlan, other servers in the server vlan should be accessible by all vlanServer are in vlan 12Server IP 192.168.1.100 & 192.168.1.101Managment_vlan vlan 14int vlan...
HiFor a small office setup with 70 users is cisco 2921 running Version 15.1(4)M4 an recommended option How do we check which IP Phone model is supported with above version. We also got 5 pieces of Cisco Cius Tablet, can these be registered on CME Te...
Hello DanielPoint#2 on your reply is not clearwhere you point the entry of dhcp server on the AP to use local dhcp serverhow to authenticate users when wlan link is down on remote AP guest ssid at remote office should get same ip address as HQ, what ...
Hello Matewhat is the simpliest option to register the remote AP to central controller, one ap in each remote office, static ip address will be configured on APUsers should get Ip address from local dhcp server in remote office users to authenticate ...
Hello MateIf the AP is already in the Remote office, how do we register the AP with central WLCthe link shared by you is little confusing.lets say Central WLC has ssid 'data' if remote AP is registered to central AP then client can connect to SSID '...
can someone review the etherchannel===On 3750 ====interface GigabitEthernet0/25 description Connected to 6500 no switchport no ip address channel-group 10 mode on!interface GigabitEthernet0/26 description Connected to 6500 no switchport no ip address...
Hi Harmitappreicate your replyAfter downloading version 15.2(4)M on 2921 do we need to download separately the firmware for sccp or sip for needed IP Phone model. Roaming users with Iphone, BlackBerry can they register to CME and do cisco got phone a...
