Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good day,
I'm able to get around 350mbps download and 400mbps upload when directly connected to the ISP device, but when i do speedtest behind my Cisco 891F router, I don't get higher than 75mbps download and 45mbps upload. I've attached my config, ...
I've configured a Cisco 891F Router at a main site that's setup with EPL with VLAN tagging. The Main Site is the one with the Internet connection coming in, all other remote sites are going to piggyback off of it through the EPL. The Main Site Intern...
Good morning,
I'm trying to configure my 2nd WAN port on my 891F Router for a SIP Port. We have a 5 Static IP Bundle wiht our ISP. When I try to configure my second WAN port with a different Static IP that was provided by our ISP, I get the "IP Addr...
Good day everyone,
I was wondering if any on you had experience in configuring Cisco routers with a EPL setup with their ISP. Here's the deal:
We have 4 sites, we'll call them Site A, B, C & D. We've installed a Cisco 891F Router (which acts as the D...
It has the LAN subnets of all 4 location, meaning it will NAT those subnets. They are paying for gigabit internet with 100M EPL that connects and gives the remote locations Internet, the 3 remote location get over 100mbps which is intended. The main ...
I've even wiped both routers and configured them just enough for Internet to work and both were ale to ping. I have no ACL setup except for the NAT one which I put any to any and still no luck. I feel like the main site isn't NATing the LAN over at t...
in this case, it's VLAN 448, LAN at main site is 206.180.50.0/24. I've added the default route, can ping the main site WAN port, but can't get out on the internet from the 10.90.36.0 LAN from remote-site. Could this be an ACL issue?