Good day,
I'm able to get around 350mbps download and 400mbps upload when directly connected to the ISP device, but when i do speedtest behind my Cisco 891F router, I don't get higher than 75mbps download and 45mbps upload. I've attached my config, VLAN 1 is the LAN at Main building, the other 3 VLANs are remote sites connected by EPL, internet speeds are fine at all remote sites. Interface Ge 0 is the port that connects the Cisco SG300 switch and is also the port i did tests on. Here's some info on the port:
router#show int g0
GigabitEthernet0 is up, line protocol is up
Hardware is Gigabit Ethernet, address is
MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/1 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 30000 bits/sec, 23 packets/sec
5 minute output rate 31000 bits/sec, 21 packets/sec
312672 packets input, 113684588 bytes, 0 no buffer
Received 3805 broadcasts (6384 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
409256 packets output, 439190653 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
89 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
2 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
Any ideas?
