Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
In the tool/Discovery/Add Discovery
In the new discover I try to discover a Router with ssh version 2 but the port change for 200. How can change the port for ssh into in the discover?
Tengo un switch que esta monitoreado via ping e snmp. Sobre la vlan 1 y recientemente configure una vlan 2 nueva para monitorear.
Al validar localmente alcanzo las dos ip pero no reemplace el default-gateway en el switch sigue estando sobre la vlan ...
Buenas tardes, tengo una duda respecto a las etiquetas de mpls que aprende un equipo. Tengo este mensaje de error "pstorm_bcm_prog_label" hasta donde pude ver en un post del foro es por capacidad de la plataforma.
Mi duda es si hay algun documento d...
I have a switch model WS-C3850-24P but i need only work in layer 2, I can not force it to work wellI could help? License Level: IpbaseLicense Type: PermanentNext reload license Level: Ipbase Regards.
I have a problem with the card Hardware: WS -SVC -FWM -1Currently has the versionFWSM Firewall Version 2.3 (4 )FWSM Device Manager Version 4.1 (5 )The problem is that I can not enable the interfacesInterface eobc " eobc " , is up , line protocol is u...
In the discover on DNA Center, I discover a new Router, add the Router IP, SNMP Community and CLI Credencials. But a dont see the opcion for select the port on ssh.
Finally the Router has discover but on CLI fails the connection because the applianc...
Question, it is required to keep vlan 1 on the switch? Why dont you keep only vlan 2 ?
Because, before change on monitoring tool, I need rechable the new ip. We are talking about 500 switch.
Yes, I have inspection active on global policy.
Regards.
When I test this command, the router does not acceptRouter(config)#card type E1 x 0 ^% Invalid input detected at '^' marker.Router(config)#card type E1 0 2 ^% Invalid input detected at '^' marker.
