Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Experts,Kindly assist me with this Remote Access VPN issue.I have configured IPSec Remote Access VPN, using the wizard. The remote client connects to the Headquarters quite fine, obtains defined IP Address, sends packets and Bytes, BUT does not...
I have a Cisco 2951 Router with image "c2951-universalk9-mz.SPA.150-1.M3.bin". Surprisingly, it does not recognise nor does it accept VWIC2-2MFT-G703 Cards. I have also tried it with HWIC cards but the same problem.In the process o...
Kindly help to determine which IOS version on 2951 router supports the VWIC2-2MFT-G703 and HWIC-2CE1T1-PRI cards.I currently have c2951-universalk9-mz.SPA.150-1.M3.bin image on the router. I had previously upgraded to c2951-universalk9-mz.SPA.152-4.M...
Kindly assist in troubleshooting GLBP functionalityGLBP has been configured one 2951 and 3945 (using the etherswitch module on 3945) Routers, using OSPF. After configuration, the load-balancing is working properly, as the route from the local syste...
Hello Jouni,I must say I am very grateful to you. Through your patience and guidance, I was able to figure out what the problem was.I mistakenly used part of the subnet for the Internal Network as the External-Pool.From your examples, I saw the misak...
Hello,Thank you so much for the prompt response, I sincerely do appreciate it.I am currently using ASA 5520 with IOS image of 8.4(5), and asdm 7.0(2)There is ONLY one Interface which the Remote Networks need to connect to, and that same Interface is...
