Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 2 devices stuck in unknown state. I've tried to re-discover them, but there was no change in their status.Then I tried to delete them and I got the following error message:I have restarted the APIC-EM server, but I still get the same error mes...
I am trying to apply a route-map on a Nexus 5000 in order to change the default gateway for a specific VLAN.
Normally I would go with using a route map like:
!
route-map CHANGE_GW permit 10
match ip address MY_VLANS
set ip default next-hop 192.168...
I'm looking into implementing anyconnect on ASA, in the most secure way possible.
I'm thinking of using certificates as the first form of authentication and Radius as the second one.
The reason why I am considered of adding Radius authentication alon...
I've performed several upgrades since the initial installation, thus I am not certain when it first occurred.I have about 50 sites and 300+ network devices, so resetting grapevine and configuring everything again is not something that I would like to...
I went through the requested logs and they had an enormous size, so I tried to narrow it down for the sake of making the whole troubleshooting process easier.I took a backup of APIC-EM and a snapshot in VMWare, deleted all of the devices but those th...
