Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have cme 7.1 with exchange unified messaging. On the voice port I have the connection plar set to the pilot number of the UM auto attendant . I would like to create a translation rule on incoming caller id (my cell phone) that would redirect that...
I have CME 7.1 on a 2811 with a four port FXO card and 3 pots lines. I have 2 dial-peers (1 local pattern and 1 long distance pattern) for each pots dial peer. I have an ephone-dn for each pots line and each phone has a button assignment for each eph...
GreetingsI have a 2651 that has an adsl1-wic that I am using as my DSL router. I recently acquired a 2801 that I want to replace the 2651 with. I configured the 2801 the same way as the 2651 but on a reload I get the statement that saysSetup: New int...
I have been searching to find out how to allow traceroute from an inside host to an outside IP address. I have found a few articles for IOS versions prior to 8.4 but nothing for 8.4. I can traceroute from the CLI of the 5510 just fine but from a wind...
I have CME 4.2 and Exchange 2010 Unified Messaging working great, but am lost with MWI. On each of the phones button 1 is the incoming pots line. I have unified messaging configured to pick up this line as a general mailbox. It works fine from both i...
A little more info. For incoming calls I am using exchange unified messaging which presents a menu to direct the calls to the desired extension. Basically my overall needs are thisxxx x140 is ephone-dn 2000 and is incoming callsxxx x434 is ephone-dn...
Looks like I got it to work. I removed the ip nat inside statement from interface fa0/0 This is my development/learning network. I used to have the 2651 doing the Nat and a while back I added an ASA 5510 so I modified the 2651 config to have the dia...
Hi Eugen,This is a repurposed unit, meaning it was in service and I pulled it from a working environment. I replaced the CF with blank, larger reformatted unit and downloaded the IOS from the rommon promptI found this article which states the WIC-1A...
NVIO is administratively down, when I boot the router right before the interfaces change state it says Setup: interface NVIO is placed in shutdown state. From the searching I have done, it has to do with nat. If I do a show interface it says NVIO is...
