Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,
This is related to a POC setup. vEdge routers will be directly connected to the PE routers (CSR routers in POC setup). It is required to configure BGP for transport side (VPN0), therefore do we need to configure a loopback interface and a...
Hi All,
Do we need to configure SNMP in cisco nexus switches if we are going to deploy DCNM.
Please mention the steps to deploy DCNM as a OVA virtual appliance.
I need to attach F5 load balancer to ACI fabric without integrating, Customer need to attach it as access ports. Can I use the same procedure which we use for BM server attachment to ACI fabric via access ports.? Please assist me.
Are you providing only the networking for F5 through ACI?, Then you have to go as BM server on-boarding to ACI fabric. I have not got your concern clearly. If you need to advertise the subnets can do it in BD level easily as well.
Hi ekhabaro,I did go through that document, it says we need to configure loopback interface only if WAN vEdge router does not directly connect to WAN cloud. But for our POC setup vEdge router will directly connect to WAN cloud. Iam bit confused here,...
Hi,Is it all required as mentioned in the guide? In IOS we need to do some configuration under line VTY like " transport input ssh ". what about the user credentials. Will it use the username and passwords we configure in global config.Please confirm...
