Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,CCO indicates that the VWIC2-1MFT-T1/E1 module can support mixed data & voice connectivity. Has anyone configured the following solution or know if it will function?I am looking to connect an E1 PRA cct to this module and in normal day to day use,...
Hi,CCO indicates that the VWIC2-1MFT-T1/E1 module can support mixed data & voice connectivity. Has anyone configured the following solution or know if it will function?I am looking to connect an E1 PRA cct to this module and in normal day to day use,...
Hi,Have a VoIP solution with two IOS gateways.One connects directly to a lower cost mobile phone dialing unit via single POTS/voice port connection.The other gateway connects to the PSTN via primary rate.Issue:First call the mobile phone dialer from ...
Hi,Have a PIX 515, that after upgrading the software and installing PDM, startup messages report floppy, keyboard and monitor errors. PIX completes boot process and starts operating OK.Just wondering if anyone else has seen this.ThanksMark
The release notes confirm your findings:
https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9500/software/release/16-8/release_notes/ol-16-8-9500.html
Cisco StackWise Virtual
Cisco StackWise Virtual is a network system virtualization te...
Hi,You could try collecting the syslog data from the PIX and using a reporting tool like Sawmill to generate reports.See this article:http://lachniet.com/cheaplogging/Cheers!
Thanks,Solution summary:Use the same PRA b-channels for voice and as ISDN backup for a WAN connection should the normal WAN connection fail.RegardsMark
Hi,This is how I had it setup - but discovered that H.323 G/W’s are not able to tell CM that the voice-port is in use/busy, hence I have started down the dial-peer option.RegardsMark
