Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need to downgrade a WAE 7541 from the CLI as my CM is on an earlier version so I cannot do it from the CM. Does anyone have the process/ procedures for this?
I have a rule in wired MAB called VOIP Phones. I am trying to determine how the phone is getting authorized inthe switchport configuration is below:interface GigabitEthernet0/13 description Dan's Desk1 switchport access vlan 102 switchport mode acces...
I am running EBGP with 2 routers on the internet. These routers are running OSPF with Private P2P links neighbored up to my Core where I am extending the public address space to VRF. When I do any external traceroutes inbound from the internet, I a...
Has anyone had issues connecting 7604 with 6704 Zenpack 10Gbase-SR to a 6506-E with WS-X6708-10GE with X2 10Gbase-LRM? I am using MMF 62.5 fiber. The fiber test clean but the ports are not coming up.
I have a 2GB (2 x 1GB) Etherchannel configured on my WS-C3560G-48TS-S ports GI0/30-31 and would like to know if their are any switch hardware restrictions for that bandwidth? Should I build them on different groups of port. The etherchannel is conne...
I need to downgrade a WAE 7541 from the CLI as my CM is on an earlier version so I cannot do it from the CM. Does anyone have the process/ procedures for this?
If I apply that to the public side of my external routers inbound ACL, that will block ICMP totally. I am looking to enable ICMP but just do not want the private P2Ps to show up in the echo-replies. This is the example below:CAT3750#traceroute 97.6...
I am only basing it on the return message from the Error message debugger and the fact that I am not experience any such error on my second 6509 running a later firmware.
