About mel-ghazali

mel-ghazali · 03-10-2018

Hello Dears any one can tell me the procedures of signing switch certificate from Microsoft CA. as the configuration of this part is not clear in the configuration guides. This is because I need to cover the vulnerabilities regarding the switch certi...

mel-ghazali · 06-28-2016

Dears, have any one tried to disable SSLv2, SSLv3 , TLSv1.0 and TLS1.1 and keep only TLS1.2

mel-ghazali · 06-28-2016

Dears, have any one tried to disable SSLv2, SSLv3 , TLSv1.0 and TLS1.1 and keep only TLS1.2

mel-ghazali · 07-07-2015

Dears;I have LMS 4.2.5, I found it's not operating, I checked processes, and I found services shows "NOT started yet " then after failed to "Never Started".I checked Windows event viewer I found the following errors "Event ID 1 from source SQLANY 10...

mel-ghazali · 03-13-2014

Dears;can any one help ? our PI 2.0 is very very slow in response, i click and go do other job until it loads, some time it works fine for a few minutes and then back poor again. this result i can't manage any thing.ThanksRegards

mel-ghazali · 05-05-2021

Dears,Earlier we had upgraded to 15.2.7E2 but got in an issue that in stack switches when a dot1x/mab authentication from ISE with dynamic vlan assignment, when users went to Quarantine it got stuck and users didn’t reached from any where.As per Tac,...

mel-ghazali · 05-05-2021

I have a dot1x issue when i upgraded to 15.2.7E 2 , 3 or 4 that the user got stuck in quarantine and became unreachable from any where except the switch itself which can ping itany idea ????

mel-ghazali · 03-22-2018

I created a web certificate from the ca and then I issued crypto pki import TrustPointName from tftp, then creates the trustpoints. then I used this trustpoint in the http by " ip http secure-trustpoint TrustPointName "

mel-ghazali · 03-22-2018

i have the same issue too, what is the IOS version at your switch ?

mel-ghazali · 03-11-2018

the command "Crypto ca trustpoint " is not valid

Member Since	‎09-20-2007 03:55 AM
Date Last Visited	‎06-24-2024 10:46 PM
Posts	25
Total Helpful Votes Received	10

User Statistics

User Activity

Switch Certificate signing from Microsoft CA

Cisco Prime Infrastructure 3.1 "enable TLSv1.2 only"

Cisco Prime Infrastructure 3.1 "enable TLSv1.2 only"

Cisco LMS 4.2.5 "Services never started"

Cisco Prime Infrastructure 2.0 very poor performance

Re: Dynamic VLAN assignement works randomly on 2960-X after upgrading in 15.2(7)E1

Re: Dot1x not working on 15.2(7) c2960x switches

Re: Switch Certificate signing from Microsoft CA

Re: CSCue40699 - VSSHigh CPU utilization for LTL Mgr process on SP

Re: Switch Certificate signing from Microsoft CA