Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Dears
any one can tell me the procedures of signing switch certificate from Microsoft CA. as the configuration of this part is not clear in the configuration guides.
This is because I need to cover the vulnerabilities regarding the switch certi...
Dears;I have LMS 4.2.5, I found it's not operating, I checked processes, and I found services shows "NOT started yet " then after failed to "Never Started".I checked Windows event viewer I found the following errors "Event ID 1 from source SQLANY 10...
Dears;can any one help ? our PI 2.0 is very very slow in response, i click and go do other job until it loads, some time it works fine for a few minutes and then back poor again. this result i can't manage any thing.ThanksRegards
Dears,Earlier we had upgraded to 15.2.7E2 but got in an issue that in stack switches when a dot1x/mab authentication from ISE with dynamic vlan assignment, when users went to Quarantine it got stuck and users didn’t reached from any where.As per Tac,...
I have a dot1x issue when i upgraded to 15.2.7E 2 , 3 or 4 that the user got stuck in quarantine and became unreachable from any where except the switch itself which can ping itany idea ????
I created a web certificate from the ca and then I issued crypto pki import TrustPointName from tftp, then creates the trustpoints. then I used this trustpoint in the http by " ip http secure-trustpoint TrustPointName "
