I know this is an old question , that IP-Phone keeps ringing after PSTN call disconnect .
I have followed this post https://supportforums.cisco.com/discussion/10589296/capture-pstn-parameters-fxo-disconnet
PSTN --> 2811(with B-ACD TCL) --> CUCM8.6 -...
we have dot1x and MAB features implemented in a Juniper infrastructure where we can bypass non dot1x devices using local database in the switches themselves.now we will migrate to cisco and need to deploy the same mab scenario locally on the switches...
Dears, we have 2811 router with multiple servers connected to it's lan from which there are monitoring servers in between , the router suffers always from high cpu utilizationconfiguration has alot of ACLs & NAT & IPSEC Tunnel with wan bandwidth ...
Problem solved after IOS upgrade.
Another issue appeared , the caller-id enable command seems not working after adding the supervisory commands.
The caller become unknow , any comments ?
it's done , noway to do it from Cisco switch itself .can be done from Microsoft NAP to accept these account without authentication and provide Vlan directly
Hi Fnu,can we apply this situation using microsoft NAP and AD but without creating this bulk of accounts (mac address as a username and password) ??It's really strange that something like that is not available on cisco as a leader for the switching ...
Hi FNU,Actually we use Microsoft NAP for authentication with active directory,and it's not logical to create more than 500 account in active directory with our devices mac-addresses as a username and a password to be authenticated!!Juniper is smart o...
No , Logging is not enabled for ACL , also minimized ACL as much as possible regarding tunnel , how to check fragments through tunnels and how to adjust them !
