Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Scenario is, I have a huge warehouse. I want to use 1260 Access Points on walls and ceilings. ceiling is 15m high and racks are 3m high.What 5 GHz directional patch can I use? Is there a better option? So far with some planning, I want to have direct...
I need the patch for the following bug. I can't find it anywhere.. Can someone help.. I know people have used it to fix their issues before.This issue is documented in Cisco bug ID CSCsb47726. There is a pointed patch available for ACS 3.3.3 (both AC...
I have with a Location manager on a WLSE 1133. The maps are showing incorrect signal coverage despite recent AP scans. They indicate that each access point can give coverage to an entire floor. A physical survey shows this is not the case. Basically ...
Cisco state; 'To participate in WDS, infrastructure access points should run the same version of IOS as the one that WDS runs.'Can anyone tell me what the effect is if the access points are not on the same IOS version? Also, what if there is a mix of...
Ok, so this is now resolved for me. For some reason the AD accounts for both of the servers were disabled. These are now enabled and the users are authenticating ok.The fact that the domain was reachable but showing as disconnected should have been t...
Thanks for the update. Using your post as a checklist;i have WLCs of all flavours on 7.0.98.0 codei have primary and secondary ACS entries on the WLC'sI am getting the exact errors you are gettingAre you saying that a reboot of both ACS servers will ...
