WLSE - AP/WDS fails to complete full authentication phase

[Gary Smith]

I need the patch for the following bug. I can't find it anywhere.. Can someone help.. I know people have used it to fix their issues before.

This issue is documented in Cisco bug ID CSCsb47726.

There is a pointed patch available for ACS 3.3.3 (both ACS software and solution engine).

To install the patch on the software ACS, perform these steps:

1.Browse C:\Program Files\CiscoSecure ACS v3.3\Support.

2.Re-name the AironetEAP.dll file to AironetEAP.dll.bak.

3.Copy the new AironetEAP.dll to the same folder.

4.Re-start the ACS services.

To install the patch on the solution engine, perform these steps:

1.Run the autoexec.bat file from inside the patch directory.

2.Log into ACS.

3.Go to System Configuration > Appliance Upgrade Status. Choose the appropriate download.

4.Enter the IP address of the computer from which you run the autoexec.bat

file.

5.After you have uploaded the patch to the ACS, click Install Upgrade.

6.Re-start the ACS services.

Make sure to create an ACS backup before the patch is applied.

[aghaznavi]

The fix for this bug is a patch that needs to be installed on Cisco Secure ACS. In order to download the patch, open a service request with the Cisco Technical Assistance Center (TAC).

http://supportwiki.cisco.com/ViewWiki/index.php/Wireless_LAN_Services_Module_(WLSM)_access_point_(AP)/Wireless_Domain_Services_(WDS)_fails_to_fully_authenticate_with_Cisco_Secure_ACS_3.3_and_4.0

[Gary Smith]

I have got a case opened now. Thanks!

It's a patch 3.3.4 which can only be obtained from Cisco TAC.