Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Say I have a VPC peer-link that is running at 40Gb. There is a plan to switch this out to 100Gb. Currently the switches in the VPC domain are running with the primary operating as the secondary. The best practices document on VPC states with the loss...
I have 2 Cisco ASA 5512x devices in production with failover configured but no secondary addresses. If I add secondary addresses with there be a traffic interruption? Just wondering if I need to schedule a real window or if I can just put the address...
Hi all,I just ran across a strange situation - I was replacing a Pix with an ASA and I couldn't get any traffic to flow to the new firewall from an edge 2651 router. The router was configured for rip on all interfaces (I have no idea why) and also h...
Perhaps I'm missing it but is there a way to find the serial number of a NAC device while in CLI? - IE Show Version on a router.I have not been able to find the serial in the GUI and I don't want to travel to get it. I'm assuming the only way is to v...
I have a light indicating a failed drive on the UCS. I can't seem to find the same indication on the UCS Manager. Where should one look to find a drive failure? I've looked through and everything appears normal.
Just tested this in a lab and whatever switch is operating as the secondary will have all it's links shut down if the peer-link is disconnected/shutdown. The safest way to complete a change on the VPC peer-link would be to manually disable all links ...
I've figured out the problem....One of my partners reloaded the Ap with Autonomous code which explains why it was autonomous. I knew it just doesn't happen. Thanks.
