Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
is LAP1142n supported 802.11ac?AC mode is enabled in High Thoughput. But no device in 100 devices is connected in AC mode.i tried with a latest notebook with intel Wi-Fi 6 which is also connected in Wi-Fi 4 (802.11n)any idea? Thanks a lot.
We have 12 APs (AIR-LAP1142N) connecting with controller 5508 One of the APs is always downTue Jun 8 10:01:24 2021 AP Disassociated. Base Radio MAC:24:b6:57:ae:c3:504 Tue Jun 8 10:01:24 2021 AP's Interface:1(802.11a) Operation State Down: Base Radio ...
10 years ago, Controller 5508 was set up with 12 APs (1142N)Yesterday, the controller was upgraded from version 6 to 7.9 APs is OK, 1 is OK after reset, 2 are failed (not joined) even after reseti found this post very similar with my case, https://c...
the dhcp 200 IPs pool is used up, some wifi clients should leave but occupy the IPsit can be solved by shortening the lease time (10hours) but the colleagues have to reconnect again.is there any way to release the IP? not to wait for expiry timewlan...
the WLC 5508 is setupLAP1142 can join the WLCMy iphone4 can join the Wireless network andget IP 169.254.250.114sub mask 255.255.0.0but no gateway, no dnswhere can i assign ip range, gateway, dns for the mobile devices? thanks a lot.tony
upgrade from 7.4 to 8.0 and reset of the AP, it still has lots of up and down from this AP in office hours. AP's Interface:1(802.11a) Operation State Up: Base Radio MAC:24:b6:57:ae:c3:50 Cause=Indicates that while the radio state should be updated on...
Thanks a lot. It is OK after runningconfig ap lifetime-check mic enableconfig ap lifetime-check ssc enable do i need to reverse the above commands after APs are joined?Have the certificates in APs being updated after APs joined the controller? Than...
i've set the DHCP scope at WLC/controller/internal DHCP serverbut i think it is for LAP, not for the wireless clientbecause LAP gets the IP from this rangeam i correct? how about the wireless client connecting to LAP?thank.s
