Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have set up a new ACS 5.1 appliance and it seems to be going well. I would like to be able to restrict access to the command SHOW CDP NEIGHBOR DETAIL to a specific group but continue to allow SHOW CDP NEIGHBOR.I am able to either allow access to t...
I am experiencing a higher than expected CPU Utilization on a 2821 router at one of my remote locations. Can anyone explain what DHCPD Dynamic Up is, if it is necessary and how to shut it off if it can be shut down?Thanks..Router#sho proc cpu | excl...
I am having an odd problem. I have a 2 port MC-T2 card installed in a 7206VXR in slot 5. Port 5/0 is behaving as expected. We are bring up a new Channelizes DS3 on port 5/1 and I am getting behavior that generated the output below when I issue the...
I am having difficulty with a configuration on an 1841 router. I am just trying to connect the 2 ethernet interfaces to different IP networks and route between them. When I apply the attached config I am able to ping devices on each network, from t...
I need to provide the same IP address to some specific devices and just regular DHCP to others on the same subnet. What is the easiest way to do this? I have about 10 devices that need to have specific addresses based on their MACs and the rest can...
I am experiencing some strangeness with the Nexus 7k and NTP. I have switches on the management vlan that are able to sync with the Nexus for NTP but when I try and sync a WAN router on another interface I am unable to. Any thoughts on this?Thanks...
That worked GREAT!!! Thanks.. I think I was missing the final "s" when inputting the command into the ACS. Show CDP Neighbor detail is different than show CDP neighbors detail.Thanks again for you help.
Yes, The router writes the DHCP database to the FTP server at regular intervals.#show ip dhcp databaseURL : ftp://anonymous:router@10.16.1.19/router-dhcpRead : Feb 24 2010 09:24 AMWritten : Feb 24 2010 01:04 PMStatus : Last write succeed...
Below is a section of the log with DEBUG IP DHCP SERVER EVENTS turned on. Certainly doesn't look as though the router is overwhelmed with DHCP requests.Router#sho logSyslog logging: enabled (1 messages dropped, 1 messages rate-limited, ...
