p-blake
Level 1
Level 1
Member since ‎01-26-2005
‎08-18-2017

User Statistics

  • 42 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
40 Discussion Posts
5 Discussion Posts
30 Discussion Posts
20 Discussion Posts
First Discussion
First Question
10 Discussion Posts
1 Reply
20 Replies
10 Replies

User Activity

I have set up a new ACS 5.1 appliance and it seems to be going well.  I would like to be able to restrict access to the command SHOW CDP NEIGHBOR DETAIL to a specific group but continue to allow SHOW CDP NEIGHBOR.I am able to either allow access to t...
I am experiencing a higher than expected CPU Utilization on a 2821 router at one of my remote locations.  Can anyone explain what DHCPD Dynamic Up is, if it is necessary and how to shut it off if it can be shut down?Thanks..Router#sho proc cpu | excl...
I am having an odd problem. I have a 2 port MC-T2 card installed in a 7206VXR in slot 5. Port 5/0 is behaving as expected. We are bring up a new Channelizes DS3 on port 5/1 and I am getting behavior that generated the output below when I issue the...
I am having difficulty with a configuration on an 1841 router. I am just trying to connect the 2 ethernet interfaces to different IP networks and route between them. When I apply the attached config I am able to ping devices on each network, from t...
I need to provide the same IP address to some specific devices and just regular DHCP to others on the same subnet. What is the easiest way to do this? I have about 10 devices that need to have specific addresses based on their MACs and the rest can...
Community Statistics
Member Since ‎01-26-2005 08:11 PM
Date Last Visited ‎08-18-2017 03:56 AM
Posts 42