Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We have two FI6248 in a cluster that should be connected to two MDS SAN switches, using FC ports.However, i am not able to configure the ports on the FI.There is no "Configure as FC Storage Port" option. I only see "Configure as FCoE Storage Po...
We have two ISE servers that will act as primary/secondary in a high availability setup.The ISE 1.0.4 installation guide, page 93, mentions that "If you have two Cisco ISE nodes configured for high availability, then you must include both the primary...
Dears,I have a case for an LMS 4.0 running in a Live environement (With devices already discovered and organized into seperate groups), where the Device Credential and repository DCR is showing suddenly as empty and only i can see the groups listed, ...
Hello,I am deploying a NAC solution v4.8.2 and i need to use active directory SSO for login and authentication.However, i have two seperate domains. Domain A and domain B. Both domains have a trust relationships with each other.In case i configure NA...
I have a new NAC Manager server for a fresh deployment. I logged in using root password with a serial connection to the server.I can't seem to be able to run the "service perfigo config" command to perform the initial CAM configuration.[root@nacmanag...
As explained, I did a right click on the unconfigured port, and all i can see is options like "Configure as Ethernet Uplink", "Configure as FCoE Storage Port" and "Configure as Appliance Port".There was no option of "Configure as FC Storage Port" or...
Dear Marco,Try the below 5 steps procedure, and let me know the end result.STEP 1:Check that the services are all running as expected. The services should have this status in a normal condition:Start -> Control Panel -> Administrative Tools -> Servi...
Download from Cisco the lms4.0.1-win-consolidated-cs-sept2011.zip patch, extract it to a folder in C:\ (Not in the Ciscoworks root directory).From the command line CMD, go to the bin directory in Ciscoworks CSCOpx\bin and run the command:perl C:\fold...
What is happening when you are booting from a CD where NAC ISO is installed on it?Usually, during boot, you should receive a installer welcome message:"Cisco Clean Access 4.8.2 Installer (C) 2011 Cisco Systems, Inc. Welcome to the Cisc...
Download the latest NAC 4.8.2 ISO image from Cisco Website.Burn it to a DVD or CD as bootable.Boot the server from that DVD/CD.Follow normal installation instructions as per the installation guide.
