Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Cisco SGE2010 switch. I have tftp'd the config off the switch. I have been looking for directions as to how to restore that config. Does anyone have any idea as to how this is done? Thanks.John
We currently have 3 VLANs setup for our organization. We have several WS-C2950G switches and one WS-C3550 switch, which the VLANs are talking correctly. We just purchased a new SGE2010 switch. I have setup the VLANs on the new switch. Unfortunately, ...
I have an Aironet 1200 with 3 SSID's attached to 3 vlan's. I need to create a way to get all vlan's over wireless, to a wireless bridge (WET200), where I can then setup the ports for specific vlan's. I cannot change the aironet over to a bridge. I ne...
I have 2950G-48 switch. One of the ports is disabled on it and I am unable to enable that particular port. Everytime I choose the status enable option, under port settings, choose OK and go back in to look at the port, it still says disabled. I am us...