Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I want to use Duo as a RADIUS server for RA VPN. The firewall being used is FTD version 7.2.10, and the Duo Authentication proxy is 6.6.0. However, the VPN connection is failing. Enrolled device is receiving Duo notifications, and after approval, the...
I am planning to deploy posture assessment in my environment. I have three clustered ISE nodes v3.1, all with PSN enabled, two admin and monitoring roles (primary and secondary). So, I need your expertise/advise in the best/ recommended deployment mo...
I have upgraded from Cisco Anyconnect 4.10 to Cisco Secure client v5.1.1.x but the Network module (NAM) is failing to connect to a 5G modem router through Wi-Fi, but with a 4G router can connect. When I roll back to Cisco Anyconnect and connect to a ...
I have built a 0home virtual lab and it comprises the following devices: CISCO ISE 3.2, Windows Server with CA,AD,DNS roles, and an access switch serving as NTP and NAD.ISE and AD are integrated.ISSUE: when i test RADIUS authentication on the switch ...
We have the Cisco Switch of S/N FCW1932A20H under smart-net care, it has been in a critical state due to A hardware component triggered by Gi1/0/27 Bias Current Sensor and subslot 0/0 transceiver 2 Rx Power Sensor.I would like to get advice from the ...
I HAVE SHARED THE PACKET CAPTURE FOR YOUR APPRECIATION. 192.168.2.5 IS THE DUO PROXY SERVER, 192.168.2.254 IS THE INSIDE INTERFACE ON THE FIREWALL, AND GATEWAY FOR THE DUO PROXY SERVER.
Chnage the authentication mode to multi-domain. here is the command.int g0/1 authentication host-mode multi-domain multi-domain: Only 1 mac address can be in DATA domain and only 1 mac address can be in VOICE domainthere is no need to put "switchp...
