About jfellenbaum

jfellenbaum · 10-12-2011

CUCM 7.1(5) - I have many phones that have a phone load specified in the phone load name field. Is there a way to clear this field using the Bulk administration drop down? Thanks

jfellenbaum · 05-11-2004

Can a loopback interface be specified in the session target command when configuring dial peers for FXS ports? Currently using a physical address and have an application that needs to specify a logical address. Will try in lab environment. Just wo...

jfellenbaum · 10-13-2011

As a side note - when you click submit - check the status of the submitted job via the Job Scheduler under Bulk Administration - Activate the Job if Necessary - If the Job has a status of "Pending", then make sure that the following services are act...

jfellenbaum · 01-12-2007

Look very carefully for the following line: Press any Key To start configurationYou have about 2-4 seconds to hit any key and it will bring up the configuration menu on your screen. I can see from your output that you have not attempted to chang...

Member Since	‎09-10-2002 04:23 PM
Date Last Visited	‎09-04-2020 12:05 AM
Posts	4

User Statistics

User Activity

Is there a way to clear the "Phone Load Name" field via Bulk Administration?

Loopback interface as dial peer?

Is there a way to clear the "Phone Load Name" field via Bulk Adm

Re: cannot access menu prompt for IPVC 3515 MCU