Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Got a refurbished AP1100, had an IP which is not the default IP on the AP, anyone knows how to reset it it to the factory default? Tried pressing the mode button, but still cannot access the AP. FYI- there is no console or serial port on the AP unlik...
I set up my Linksys wireless AP to be a CLIENT to AP 350. Both operates in the same channel. In the Event Log of AP350, I noticed both devices show several attempts to associates/Dissassociates. Does a difference in transmit power in both devices ca...
Does anyone know what a correct CLI or procedure to upgrade an old 2501, the router does not recognize "copy tftp flash:" command (It only has IOS v10.2(5). I don't intend to upgrade the ROM: System Bootstrap, Version 5.2(5). Thanks.
Bought a used PIX Restricted L and Intel FE card. Received these output during bootup:PhoenixPICOBIOS 4.0 Release 6.0Copyright 1985-1998 Phoenix Technologies Ltd.All Rights ReservedBuild Time: 04/27/99 17:08:34Polaris BIOS Version 0.09CPU = Pentium w...
Hello, can anybody tell me the command to identify whether a PIX has a VPN accelerator card installed(without opening up the chassis) in it in order to get the info (e.g type of card - whether it is VAC or VAC+). Thanks.
Actually, what I am trying to do is making the Linksys client AP a Cisco Workgroup bridge and NOT as a repeater. I recall from my reading on Cisco website that I need to enable " Associate with NON- Cisco Aironet", however, I could not find this on t...
Receiving the same error on 2611XM vc2600-i-mz.122-11.YT2.bin with WIC1 DSU T1 installed. The router detected the WIC and interface but showing the same error messages.Pls advice.
Still cannot vpdn into this router with this config. FYI - the router is connected to a cable modem for Internet connectivity. Do I need to specify certain protocol? I ran the debug vpdn on the router, the router didn't even see the attempt. Any idea...
--begin ciscomoderator note-- The following post has been edited to remove potentially confidential information. Please refrain from posting confidential information on the site to reduce security risks to your network. -- end ciscomoderator note -- ...
