Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,Im configuring a wireless network, and currently my network works but I have a employee ssid, and guest ssid. My employee network works fine, and I can pull a dhcp. When I connect to my guest ssid I am still pulling from my employee DHCP serve...
Hello everyone,I am attempting to deploy a wireless solution, and can ping my ap from the controller, but can not see the ap in the controller. I believe there is a firmware issue. Can I have a second pair of eyes on this as of now the ap does get an...
Hi everyone,I was wondering how to load a custom .aef script into a UC560 everything else I come accross is either CCM or CCME for another platform. Thanks,Jeff
Hello,I need another set of eyes on my config. I am trying to set up my router for a basic connection for the time being. I set my gig 0/0 port to dhcp I see traffic being sent and recieved but I can not ping 8.8.8.8. I am connected to a basic comcas...
I have a 2960 and a 2811 with a hwic card I have one port set as 100 meg and another port set at 10 meg. Both are set to access mode. i need one port for failover (10 meg) . I can't do etherchannel on the hwic. How do I prevent a loop when I connect ...
Yes that is what I was trying to go for originally but it did not seem to work. How do I properly configure this to work as you stated above. I do apologise for my ignorance this is my first deployment with dual DHCP pools. normally my guest network ...
Hi everyone,I had no luck with the runbooks and I had to use CCA to upload my .aef script to save some time. When I click on configuration > telephony, and add the script they upload fine. I click save configuration and it should be saved to memory. ...
