Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
So I deployed two Firepower 1010s in FTD mode in August -- and they both stopped working today --
FDM showed the ports as all greyed out -- except for the MGMT which was green.
The physical LEDs on the 1010 and switch showed as green.
License says ...
Looking for advice on an CME3.3/CUE2.2 implementation for a school. On the old phone system the principal was able to effectively send an individual page to a classroom, if the teacher did not answer the phone while they were teaching.School has abou...
I have a 1751-V with CME and 2 port fxo with 2 pots.On a 7960 with 2 extensions I would like to be able to map all outbound calls from extension 1 to fxo port #1 and ext2 to fxo#2.As per: http://www.cisco.com/en/US/partner/tech/tk652/tk90/technologie...
I split the POTS line and terminate on an 1751-FXO card and also on an Analog phone. When a call is answered on the analog phone, ringing is still heard on the line, in otherwords FXO didn't recognize the call was answered. When I answer the call wit...
Thanks -- but I think your behavior was a little different -- your boxes rebooted -- mine stayed up just stopped passing traffic. Also there isn't any vpn configured -- so flow-offload may not even be in-use.
Also from a timing perspective unlikely...
Thanks for the confirmation.
Just odd that two firepowers1010 at two distinct locations -- that were staged and probably configured on the same date in August -- shutdown on the same date in December.
Just seems that a license timer is a factor.
This doesn't work for me. I do see call come in with caller-id, but looks like not being sent to cucm.Any help is appreciated.ThanksAndrewios is 15.2cucm is 8.5.1ccm-manager mgcpno ccm-manager fax protocol ciscoccm-manager music-on-holdccm-manager co...
