Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
For my home lab, I just purchased the above referenced EtherSwitch module. I get this pertaining to the card on boot:
Press RETURN to get started!*Oct 14 14:58:22.307: %PA-3-NOTSUPPORTED: PA in slot1 (Unknown (type 65535)) is not supported on this ...
I'm having issues with:1) I can't get to the internet from a host (11.1.1.3) connected to SW-02-C2950G2) I can't ssh from a client connected to the Airport Extreme. This used to work but when I enacted NAT I lost the ability to SSH.3) Fr...
What am I missing?I've got a verizon fios router (IP 10.1.1.2) acting as DHCP server for network 10.1.1.0/24. I have a route configured: destination: 192.168.10.0/24 and gateway 10.1.1.2.Connected to a Cisco C2950G all in VLAN1 (to be edited later) d...
Leo --
Thanks very much for the response. After implementing your suggestion (with no improvement unfortunately) I removed the router and took out the non-ECC DIMM RAM card to see if that would allow the router to recognize the ES card when ECC was...
Here we go. This is how honest I am, I pasted the two startups both from a "T" train IOS and an "M" train IOS including my screwup when I didn't state the disk for the new boot statement. Please note that the vendor I purchased the NME-XD-48 EtherS...
Thanks to those who replied...and yes, my routes were bad. Instead of the following routes:ip route 0.0.0.0 0.0.0.0 FastEthernet0/0ip route 10.1.1.0 255.255.255.0 FastEthernet0/1ip route 192.168.10.0 255.255.255.0 FastEthernet0/0I should have had the...
