Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 2581 router with an etherswitch installed, configured and routing back and forth but this is done with a physical patch cable connected from gi 0/1 (R) to gi 1/0/1 (S). I would like to have the connection made using the internal gi connecti...
I have downloaded CCP Express from CISCO, copied it to the router, extracted the file to the flash, configured the router as shown below but I am not able to get the CCP Express page to load. I am able to login when I try connecting to the routers IP...
Hey,
I'm pretty new to Cisco commercial equipment's but I'll get straight to the point.
I have a Cisco 2650 with a NM-16ESW module installed, I have vlan 10, 30, 80, 99, and 150 setup. I have a DHCP server handling IP addresses for all the vlans acc...
Hey, I have a 2851 router with a NME-XD-48ES-2S-P installed. I have read that it's best to have the port that communicates with the router set to "no switch" with an IP address, but my setup only works with the port in "switchport trunk mode" to pas...
