Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,Hope someone can give me a difinitive answer on this.Devices i have in use are:TACACS+ running on Cisco Secure ACS 5.2 (patch 5-2-0-26-10) on a 1121Cisco MDS9000 series SAN Switches (Been told it's at SAN IOS 5)I've carried out the following...
Hi all,I'm having issues trying to dial into the network via ISDN. Setup is1. Users dial in via ISDN PRI/BRI or POTS.2. Users using PRI/BRI don't have a problem3. Users using the POTS modem way are getting disconnected after approx 5 sec...
Hi there,I'm hoping someone can assist. The setup i am trying to get working is the followingUser dials in over POTS to an ISDN30 Line. The ISDN30 line (3rd Party Supplier) is connected to our 2911 via a HWIC-1CE1T1-PRI module. W...
Hi Paolo, Many thanks for this, all sorted. Made a dial in call and managed a continuous ping for 7 minutes before i tore the call down.You've been a great help,CheersKenny
Updated the IOS but made no difference. Turns out i was missing the line 'network-clock-participate wic 0' Added this to the config and managed to get incoming POTS calls. Only problem now is that the PITS call won't stay up for more than 5 secon...
