Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Who is anybody using a WISM with FWSM on CAT 6500 switch ?Are there any problem,if use?And How can I set them to connecting each other ?I have founded a document relate it on the cisco website that name is Integrating Cisco WiSM and Firewall Servi...
HiI have a plan to upgrade our network.I am worndering that use both Gre over Ipsec VPN and Voice Gateway on 2811 ISR.I think that ISR supports all of these feature.You know, however, Are there some problems, if I set like this?Let pleasw me know, If...
I had an experience which Backbone switch had rebooted .And then someting happened a problem what I could not ping to a access switch'smanagement IP which connect to backbone.However, all of services are ok, It just an access swich managemet IP probl...
Our compny is serviceing Mpls between HQ and Branch. PE<->PE is running EBGP through ppp multilink and PE<->CE is running OSPF.The PE router is a cisco 3845.When I configure, it is working well. In case CE<->CE, I can a ping each other, but I can not...
I had also experienced as you had.I drived me crazy and so I re-installed acs program using restore Cd which it comes with new appliance.It is working well and problems had gone.try it.
The first, You should check your NVRAM or you have to find where start-config.cfe is being.please type the command:dir all:and then type the command: copy nvram:start-config.cfg tftpIt could be copy to your tftp-server.
