Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I recently bought a 3845 off ebay to replace my 3745on my 3745 I used 3x NME-16ES-1G-p for intervlan routing and had the full ac+inline power setup so I was able to power my AP via POE without a injector (and one NM-1GE for connection to a D3 cable m...
Ok first I'll go over my setup and then the problem I have.Comcast SMCD3 cable gateway (required for statics with bisiness class service.Cisco 3745 w/ NM-1GE (link to the SMC) and 2x NME-16ES-1G-Pthe NM-1GE is GI 2/0the links to th...
I have a AP1242AG access point at home with my 3745 router and 2960G switch and I want to be able to use the roku android apphttp://sdkdocs.roku.com/display/RokuSDKv48/External+Control+GuideSo as it can't discover it, does anyone k...
I worked out my issue with getting data to pass through my new nm-1ge module but now shortly after switching over to it and giving it a fair bit of traffic the router crashesI've attached the crash info file hopefully someone can help
I just installed a NM-1GE into me3745 but something seems wrongI can't get any data to pass (I even connected a computer directly and set the interface to an IP of 192.168.200.1 and the computer to 192.168.200.2 and the computer couldn't ping 192.168...
Ya I think thats about right.Comcast didn't exacly go with the best solution for the way they do staticsthe SMC does a form of secure RIP to communicate witht eh CMTS and while they did use a Cisco 1805 at some places (not mine thoguh) back in docsis...
oh man am I mad at comcast nowafter hours of troubleshooting the router I just power cycled the cable modem (SMC D3 acting as a pure router) and now it worksseems like it didn't want to reply to my new router for anything but the 33 till I power cycl...
LOGIX-Router#ping 4.2.2.2 source lo 1Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 4.2.2.2, timeout is 2 seconds:Packet sent with a source address of 10.254.254.0.....Success rate is 0 percent (0/5)LOGIX-Router#sh ip nat tPro Inside...
for testing I've now shutdown gi 1/0, 3/0 and 4/0and changed acl 1 to include loopback1and added ip nat inside on the loopbackI issued the follosing list of commandsint gi 1/0shutint gi 3/0shutint gi 4/0shutexitno access-list 1access-list 1 permit 1...
