Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
In previous vPC setups with N5k (or also N6k), I had to use the 'vpc bind-vrf' command to ensure the forwarding of multicast over the vpc peer-link, especially for receivers in in non-vPC VLANs and the receivers connected to Layer 3 interfaces.I am w...
We are wondering about a vPC peer-switch setup whis states to be non-operational!We are running a Cisco Nexus 7010 vPC pair against a Cisco 6500 VSS setup.The VSS system is the root of the MST (STP).We have enabled vPC peer-switch feature on the N7ks...
Hi Eng Wee,PBR on the Nexus 5548 should be supported since release 6.xCheck out the following URL:http://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5500/sw/unicast/6_x/cisco_n5500_layer3_ucast_cfg_rel_6x/l3_pbr.htmlGreetingsStephan Strack
Hi Andy,
thank you very much for answering this question - I did already suppose that it works with the N7K without configuration of such a command.
But it is really good to know that it behaves indeed that way
Thank you very much again!
Stephan!
Hi Kristof,thanks for your reply - that's a very usefull hint!But this implies that the peer-switch feature could never be used, if there is more than one vPC pair in any kind of STP setup (or could only be used on one (the STP-Root-Owner) vPC pair),...
Hi Saulius! Most the phenomenons you described and the 'so called' solutions can be found in the white paper of NLB on Microsoft page.http://www.microsoft.com/windows2000/docs/NLBtech2.doc
