Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I just installed a new cisco 2921 router on a remote MPLS location. I applied an acl to the wan port of the 2921 and I am not getting any "hit counts" on the acl even though the last statement on the acl is "any any". Is there something I need to a...
I am new to wireless. I would like to statically assign ip addresses for my controller(AIR_WLC-2112) and my access point (LAP1042N). I would then like the controller to distribute dhcp addresses for users. What is the best way in doing this?
Thanks so much for the reply. So trunk port to controller but access mode to AP. 2 dhcp scopes for the 2 different wireless SSID's. You can limit your traffic off the WAN by keeping the wireless traffic local on the switch...do CAPWAP tunneling f...
I would like to statically assign my controller and AP's and use the client to get dhcp through L3 switch. I would like to use the L3 switch to have 2 separate dhcp scopes for 2 separate SSID's. One for employees and one for Guests? I would assume...
Thanks. I would like to set up the dhcp server on my layer 3 3750 switch that the devices would be connected too. Anything special that I need to consider in doing this with the Controller?
