I just installed a new cisco 2921 router on a remote MPLS location. I applied an acl to the wan port of the 2921 and I am not getting any "hit counts" on the acl even though the last statement on the acl is "any any". Is there something I need to activate on the router?
interface GigabitEthernet0/0
ip address 10.110.174.21 255.255.255.0
ip access-group test in
ip accounting output-packets
duplex auto
speed auto
ip access-list extended test
permit ip 10.241.50.0 0.0.0.255 host 10.110.174.20
permit ip 10.241.50.0 0.0.0.255 host 10.110.174.21
permit ip any any
Extended IP access list test
10 permit ip 10.241.50.0 0.0.0.255 host 10.110.174.20
11 permit ip 10.241.50.0 0.0.0.255 host 10.110.174.21
20 permit ip any any
