Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Not sure if this is a bug with ASDM, but when I try to add a virtual interface through ASDM I receive the following error when clicking 'Apply'...
"With the current license device will only supports 2 fully functional interfaces. Third interface ...
Hi, Consider a small LAN using a collapsed core design with two Catalyst 3650 switches in a stack as the core/distribution layer. There are several 2960X switches with cross-stack EtherChannels to the 3650's. After enabling Rapid-PVST, best practice ...
Hi,We've had contradicting advice on AnyConnect licensing. We currently have two 5520 appliances in active/standby, each ASA had an AnyConnect Premium (50 peers) license installed, but following the (very sensible) change in 8.3 (I think), the total ...
Hi all...On a Cisco 5508 running 7.4.110, is it possible to configure the AP Mode on multiple acess points. I have around 15 new APs, but don't particularily want to go into each indiviual one to change the AP Mode from Local to FlexConnect.Can't see...
Hi,We have a 5508 WLC at our main site, with an 1141 AP at a remote site that is connected to the main site via an MPLS network. The AP is configured to use FlexConnect mode.I have a guest WLAN configured with the following key attributes:Seperate in...
Just regarding the compatibility of the C3850-NM-4-10G module, I note from Richard's original article that only 48 port models support this network module....
"C3850-NM-4-10G
This module has four 10-Gigabit slots or four 1-Gigabit slots.
Note This is...
Cisco changed the licensing model a couple of years back so that rather than having a "shared licensing server", paired ASAs that have individual licence packs installed (i.e. 50 SSL VPN licences on each ASA), now count as 100 usable licences, wherea...
.png "tonymitchell"){kind=avatar}
